Details
- Center hole: 5/8"
- Requires 2 blades for 30" cut
- Tungsten carbide is “fused” into the blade – creating an ultra-hard layer at the cutting edge and increasing the time between sharpening
- X-Tended Cutting Length™ optimizes the cutting efficiency with each revolution
- Gator Mulcher® provides cleaner, more efficient cutting performance can eliminate the need to bag, saving time and hassle
- The aggressive blade angle increases air flow to push debris up-and-out for superior bagging or side discharge
- Fits Toro Model: 22200 Turfmaster walk-behind
Blades
| Blade Width Measure near the center of the blade. | 3.00" |
| Blade Thickness Measure near the center of the blade. | 0.134" |
| Blade Length Measured diagonally from the corners of the blade | 15-3/8" |
| Outer Hole Diameter This is the diameter of any holes to the sides of the center hole. | 5/16" |
| Center Hole Size Many blades will have a round hole in the center of the blade and you will need to know its diameter. Blade Length 5 or 7 Point Star Center holes may be 5 or 7 point star shaped. 5 point star on blade7 point star on blade Square or Rectangular The MTD built blades on many walk behind lawn mowers have a 'bow-tie' hole. In this case the Oregon replacement blade will have a rectangular center hole which will fit on the bow-tie pattern on the blade adapter. Square or Rectangular hole on blade MTD Blades The MTD® built blades (Bolens, Cub Cadet, Troy-bilt, White, Yard Machine, and Yardman) may have a 6 point star. Oregon replacement blades will have a 'Y' shaped center hole which will fit exactly on the 6 point star on the blade spindle. 6 point star for MTD blades The two sizes of the 6 point star. If your blade spindle has a bolt and lock washer that holds the blade to the machine you would use the 11/16" star or 'Y' blade. blade spindle with bolt and lock washer. If your blade is secured with a large flange nut then you would use the 5/8" star or 'Y' blade. blade spindle with large flange nut | 5/8" |
| Center-to-Center If there are outer holes; this is the distance between the centers of those outer holes. | 1-1/4" |
| OffSet (Sometimes referred to as offset): If you set the blade on a table this is the distance the center of the blade is above the table top (if any) when the cutting edges are flat on the table | 5/16" |
| Air Lift Air lift is the distance the lift panel rises above the cutting edge. | 1" |
| Gator Blade Series | Gator® G5™ |
General
| Color | Black |
| Product UOM | Each |
| Weight (with Packaging) | 1.78 Lb |
| Product Height | 0.134 |
| Product Length | 15-3/8" |
| Product Width | 3 |
