Genuine Oregon Mulching Blade, Gator G6 , 16-1/4"""" rpls Exmark 103-8250 392-205


MSRP: $27.88
(You save $11.39 )
(No reviews yet) Write a Review
Adding to cart… The item has been added


  • Center hole: 15/16"
  • Tungsten carbide is “fused” into the blade – creating an ultra-hard layer at the cutting edge and increasing the time between sharpening.
  • Greater width and thickness extends blade life and allows for longer lifting arch to improve bagging and mulching.
  • The aggressive blade angle increases air flow to push debris up-and-out for superior bagging or side discharge.
  • Gator Mulcher® provides cleaner, more efficient cutting performance can eliminate the need to bag, saving time and hassle.
  • X-Tended Cutting Length™ optimizes the cutting efficiency with each revolution
  • Replaces major brand: Exmark


Blade Width Measure near the center of the blade.3.00"
Blade Thickness Measure near the center of the blade.0.250"
Blade Length Measured diagonally from the corners of the blade16-1/4"
Center Hole Size Many blades will have a round hole in the center of the blade and you will need to know its diameter. Blade Length 5 or 7 Point Star Center holes may be 5 or 7 point star shaped. 5 point star on blade7 point star on blade Square or Rectangular The MTD built blades on many walk behind lawn mowers have a 'bow-tie' hole. In this case the Oregon replacement blade will have a rectangular center hole which will fit on the bow-tie pattern on the blade adapter. Square or Rectangular hole on blade MTD Blades The MTD® built blades (Bolens, Cub Cadet, Troy-bilt, White, Yard Machine, and Yardman) may have a 6 point star. Oregon replacement blades will have a 'Y' shaped center hole which will fit exactly on the 6 point star on the blade spindle. 6 point star for MTD blades The two sizes of the 6 point star. If your blade spindle has a bolt and lock washer that holds the blade to the machine you would use the 11/16" star or 'Y' blade. blade spindle with bolt and lock washer. If your blade is secured with a large flange nut then you would use the 5/8" star or 'Y' blade. blade spindle with large flange nut15/16"
OffSet (Sometimes referred to as offset): If you set the blade on a table this is the distance the center of the blade is above the table top (if any) when the cutting edges are flat on the table3/8"
Air Lift Air lift is the distance the lift panel rises above the cutting edge.1"
Gator Blade SeriesGator® G6™


Volume375.103 in3
Product UOMEach
Weight (with Packaging)3.183 Lb
Product Height0.25
Product Length16-1/4"
Product Width3
Packaged Length22.9"
Packaged Width6.3"
Packaged Height2.6"



103-8250, 103-8250-S, 103-8251, 103-8251-S, 103-8288, 103-8288-S, 103-8296, 103-8296-S, 103-8370, 103-8370-S, 103-8420, 103-8420-S, 103-8433, 103-8433-S, 103-9614-S, 109-6460, 109-6460-S, 109-6466, 109-6466-S, 109-9390, 109-9390-S, 116-5496-S